Results 1 to 10 of 10
Thread: ABS not sticking to heated bed
Threaded View
-
08-20-2021, 09:32 AM #10
I made a enclosure with a single sheet of plywood Photo below
Enclosure.jpg
Example1.jpg
Enclosure 2.jpg
The Last photo show that I have clear plastic front doors that do not completely cover the front this was by design.
I wanted to have a small breathing hole for ventilation purposes, I have a bathroom fan in attached to the back wall with a dinner control to adjust the fan speed.
I have made few changes to the enclosure like a Quad 120 Vac socket, An some tool storage holders.
yes I use enough fan speed to remove the ABS smell to vent outside my home.
This slight breeze has never effected one of my prints as shown MPCNC Middle Assembly photo below.
Middle Assembly.jpgLast edited by Roberts_Clif; 08-20-2021 at 09:38 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help