Results 1 to 1 of 1
-
08-14-2021, 05:11 AM #1
- Join Date
- Aug 2021
- Posts
- 1
Possible inconsistent extrusion on the Ender 5
Bought a roll of loneessl filament and getting weird parts where I think there is barely any extrusion in spots. I tried increasing the extrusion multiplier until there was too much and no luck. The filament isn't being grinded. I just to make make sure its not a user error before going after the filament maker.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)