Fashion Designer looking to integrate 3d printed textiles

[margaret76]

Hello,I'm new to everything here, I've been watching videos on different machines for the last two weeks or so. As you all know there are tons of machines on the market, but what really gets me is that all of them have a small build area, usually around 200Mx200Mx200M. The idea I have in mind is to make singular flat pieces using flexible filaments. Now at most these panels should be around 30Inches long. I was wondering if you could start a print, and move the bottom edge of the design to the top of the print bed, and continue your design? (That could also be done in reverse, pushing the design down, and continuing from the top)

Did you check some Fashion designing companies, might be they provide this kind of service