Results 1 to 9 of 9
Thread: Tried my first print today
Threaded View
-
05-17-2014, 07:39 AM #7
- Join Date
- Oct 2013
- Location
- new jersey
- Posts
- 752
First layer plays a big part on adhesion. Be sure your z stop and or first layer height is calibrated properly. Ultimately your looking for 100% bed contact but you dont want to put out too much material or be too close to the bed because youll be dragging the nozzle through the plastic.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion