Results 1 to 10 of 354
Thread: 370mm X 250mm X 300mm
Threaded View
-
07-27-2021, 12:23 PM #11
VS Code. I am trying to get through this but having many problems. But not what you might think. I am figuring out how to get this setup and debugging ok. I just keep finding more things I want to get up an running. Like for example I see Dual Z auto align. And don't you know I am configured for it without touching my printer. I have separate Z stepper motors with no belt going into separate Z stepper drivers and a BL Touch. All I have to do is get the firmware configured for it and I never have to check that again. So it's moving along but I am still struggling with the mission creep.
That will make a huge Delta. And I think that would be a better way to go than the Tevo Little Monster. You need to finish that. Reaching your own goals in a project can be very rewarding. You should make a giant delta thread and update it regularly buddy.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion