Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 05-15-2014, 05:33 PM #3
    JRDM
    JRDM is offline
    Engineer-in-Training
    Join Date
    Apr 2014
    Posts
    228
    Quote Originally Posted by atoff View Post
    Hm... looks to be just another Makerbot 2X clone. I like Monoprice though, for their cheap cables / mounts, but this isn't the cheapest dual extrusion printer.
    No, it is not the cheapest, but this one looks better built than the cheaper ones. Going too cheap in 3D printer world can seriously ruin your weekend or even month, where spending a bit more would have been better.

    But it's very hard to tell from limited photos. I'm intrigued, but not sure if I want to be the guinea pig for this one.
    Last edited by JRDM; 05-15-2014 at 05:35 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules