Results 1 to 10 of 89
Threaded View
-
05-14-2014, 04:59 PM #26
- Join Date
- Oct 2013
- Location
- South Australia
- Posts
- 50
Yes, I was bit concerned when I saw the original design and thought that it could be a problem. It turns out I was correct. Being as I have re-designed the whole machine so far. I will take it a bit further and re-design the layout better too, making the bed carriage wider and also more symmetrical. I can definitely see some flexing when the X is extended and the nozzle presses against the bed, there is too little support under the bed at that location. I have managed to get some good prints though. so a change or two can only make the machine better.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help