Results 1 to 3 of 3
Thread: Wrecked printer
-
05-24-2021, 10:26 AM #1
- Join Date
- May 2021
- Posts
- 2
Wrecked printer
Hi.
I have two printers. Massportal Pharaoh Ed and cheaper Alfawise U10.
Unfortunately i broke my U10. Heater wires connect accidentaly to bedtemp sensor. Now Controllunit shows all the time bedtemp to 104C.
If I'm right, i proke somethin from motherboard. Where or how do i get new one with current software?
I have bought this printer when it was allready builded up, so I don't have any experience of that.
Thans for a understanding a newbie.
-
05-24-2021, 01:24 PM #2
replace the thermistor on the bed first.
It's quite likely that's all that's died.
It's a cheap part and should be fairly easy to replace.
-
05-25-2021, 03:38 PM #3
- Join Date
- May 2021
- Posts
- 2
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery