Originally Posted by
Roxy
Wow! That is a clean design!
Back to the double raising of the Z-Axis. If you agree it is doing that... Probably we should make the
#define Z_RAISE_BETWEEN_PROBINGS 2
The reason is... You only deflect less than 1mm to activate the Z-Probe. Going up a whole bunch is making the double raising too much now that the code (very likely) is getting the nozzle off of the bed after a measurment. But I don't have a machine to test on.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion