Results 1 to 3 of 3
Thread: layer help
-
05-08-2021, 03:10 PM #1
- Join Date
- Aug 2020
- Posts
- 29
layer help
on my prints i have been noticing a lip near the bottom of my prints not sure what is causing this
-
05-08-2021, 10:18 PM #2
- Join Date
- Apr 2021
- Posts
- 186
Does it occur at the same height as the "floor" on the other side of the wall?
What slicer?
-
05-10-2021, 08:43 PM #3
- Join Date
- Aug 2020
- Posts
- 29
yes it occurs at the same height i use cura
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help