Results 1 to 10 of 18
Thread: Slicers and Quality
Threaded View
-
05-06-2021, 12:25 AM #3
- Join Date
- Apr 2021
- Posts
- 186
I am the same. Used Cura heavily and started with PrusaSlicer a few years back. Ran both for a while as Cura had better support options. Then with the release of more recent PrusaSlicer builds I just switched across entirely. Haven't loaded Cura in months.
Nicest thing about PrusaSlicer is how they've broken the parameters down into Print/Filament/Printer tabs, so if you're running multiple printers, you can share most of the profiles between them.
I haven't seen much print quality differences between a well setup Cura or PrusaSlicer print. Either works well. My print time estimation is almost spot on with PrusaSlicer for all my machines, which is a nice bonus.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help