Results 1 to 10 of 19
Threaded View
-
05-01-2021, 08:28 PM #10
- Join Date
- Apr 2021
- Posts
- 186
Depends on what you end up with.
My X5SA Pro came with a busted card reader, so my upgrade path was a lot more urgent than I'd intended.
I did these changes:
Critical changes (so I could get the job done)
• Replaced print surface with magnet/PEI flex sheet (bolted down so no springs)
• Replaced board with SKR 1.4Turbo + 2209s + TFT 35
• Replaced clone bowden titan extruder with direct drive E3D titan + V6
• Marlin firmware running sensorless, UBL, individual Z, and linear advance.
Long term reliability and QOL changes:
• Mic 6 bed + 500w keenovo heater + graviflex magnetic base (still to do)
• Meanwell 600W power supply (still to do)
• Gates belts
• Toothed idlers and reinforced idler mounts
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help