Results 1 to 10 of 10
Threaded View
-
04-28-2021, 07:51 AM #3
- Join Date
- Apr 2021
- Posts
- 5
Thank you!
My current Cura settings: https://imgur.com/a/ihV8crE
If I print with this settings the stringing is almost gone but then the two towers in the test print get really weak and sometimes they just dont get printed or break immediately.
But if I turn off the retraction settings in cura the towers are way more stable , problem is I get a lot of stringing again.I also tried to lower the retraction speed , same result , very poor printed towers like on the pictures in my attachement.
I will try a few prints with much lower retraction and print speed I guess.Last edited by D4rki1991; 04-28-2021 at 08:02 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help