Results 1 to 5 of 5
Thread: Surplus Threads in Print
Threaded View
-
04-20-2021, 05:30 AM #5
- Join Date
- Apr 2021
- Posts
- 186
15mm retraction is huge, even for a bowden.
If you can post the gcode file, we can check the feedrates, but just check that fusion is working in mm/sec. it may be working in mm/min, cm/min, or in/min. If it's set to in/min, that would be about 8.5mm/sec
Also, if it's running in inch/mm then double check that retraction number. It may not be in mm either.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion