Results 1 to 9 of 9
Thread: X axis print issue
Threaded View
-
05-11-2014, 09:25 PM #1
- Join Date
- May 2014
- Posts
- 2
X axis print issue
Hi,
I am new to this forum.
I have a Mankati XT printer and have run into a problem. As pictured, the y axis printed fine but the x axis did not print properly. I have not had an
issue with small centered prints. This print attempt is 195*195*60mm. I have stopped the print at 70%.
Printing - z res- 0.1mm @ 50mm/s
- Base Layer res 0.3mm @ 10mm/s
- 100% fill
- shell thickness 1mm
- Print Temp -210deg
-Bed Temp -40deg
-Material - PLA
Any suggestions?
IMG_4801.jpgIMG_4800.jpg
LukeLast edited by luke.kiebert; 05-11-2014 at 09:52 PM.
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion