Results 1 to 10 of 174
Thread: My First CoreXY
Threaded View
-
04-09-2021, 12:05 AM #11
With all the lower corners in place I have turned the top square of the frame 180 degrees and then removed the front top bar..
Now I need to make some mounts for the X and Y motors as they would have mounted to the bar that I removed. And I have to figure out how I am going to remount the hotend carriage so it faces the front and lets the nozzle reach all the way to the rear of the bed. But this will be a lot easier to retrieve prints from. And clean the bed.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help