Quote Originally Posted by curious aardvark View Post
you can actually use the slicer to print more htan one thing at a time.

so 100mm by 50mm - and it's taking 5 hours !
What speed and layer height are you using ?
That's ridiculous - even for an ender 3 - I mean I know they are slow - but damn, that's positively glacial !

But basically the slicer will not only generate duplicates for you, it will also lay them out on the bed.
Are you using cura or prusa slicer ?
prusa slicer is better :-)

Not sure about speed and layer height. I used defaults. Powering up the the Ender 3 V2 monitor shows these settings.


Ender 3 V2 Monitor Defaults.jpg

X axis speed = 500? Presume that means 50cm / sec, which seems very high? I measured about 3s to move 200mm using the monitor