Results 1 to 10 of 17
Threaded View
-
03-11-2021, 07:13 AM #2
you can actually use the slicer to print more htan one thing at a time.
so 100mm by 50mm - and it's taking 5 hours !
What speed and layer height are you using ?
That's ridiculous - even for an ender 3 - I mean I know they are slow - but damn, that's positively glacial !
But basically the slicer will not only generate duplicates for you, it will also lay them out on the bed.
Are you using cura or prusa slicer ?
prusa slicer is better :-)
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion