Results 1 to 3 of 3
Thread: Calibration Problem Need Help.
-
02-28-2021, 10:56 AM #1
- Join Date
- Feb 2021
- Posts
- 1
Calibration Problem Need Help.
Dear Forum Members
I build a corexy 3d printer and i have a problem when test calibration prints.
Any one can help me, what problem with my prints ?
20210228_105556.jpg20210228_105607.jpg
-
02-28-2021, 09:01 PM #2
I have a couple thoughts on that. First try printing it 5c cooler. Then again 5c cooler. And again until it wont print well and understand the best temp to melt that specific roll of filament. Or just go print out the temp tower. But I think it might print better at a slightly lower temp. I also think You can enable linear advance in marlin and then tune it so you maintain the right pressure in the nozzle. If your problem persists past that you can look to acceleration and jerk/ junction deviation settings.
-
03-04-2021, 07:20 AM #3
- Join Date
- Mar 2021
- Posts
- 1
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help