Results 1 to 9 of 9
Threaded View
-
05-09-2014, 03:06 PM #9
- Join Date
- May 2014
- Posts
- 4
This is the conclusion we came to as well.
The picture linked in the article is not representative of our samples or what annealing does to the surface finish. We found that our parts did warp slightly at the higher temperature (140˚C), but perhaps some bracing while annealing would help to reduce this. I also think that people who print more decorative vs. structural parts would be less likely to need a stronger part, so annealing isn't for every print.
I hope to get our full paper linked here as soon as it is approved by our professor to do so.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion