Results 1 to 10 of 15
Thread: Calibration question
Hybrid View
-
02-11-2021, 11:06 AM #1
As fred said, print a square calibration cube. You can adjust the X and Y steps independently, depending on the motherboard, directly through firmware or through inserting a line of GCODE as correction at the start of each print.
-
02-11-2021, 02:14 PM #2
Yes, good idea, i will do that
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion