I have two of these One, two They have suited me well for four years time.
Today they look like the image below.


The Twins 2.jpg

Before Purchasing the 3D Printer I found the videos below and watched, wanted to know If I could Assemble.
As my 3D Printer came without assembly instructions I learned how to assemble watching these You-Tube Videos.
Part 1
Part 2
Part 3
Part 4

I have successfully 3D Printed PLA ans ABS.
Was told ABS was very difficult to 3D Print, after watching many You-Tube Videos on the matter I built an enclosure and Have never had any warping.
My Enclosure was built from a single sheet of plywood the front door is hinged from top using two clear plastic sheets.

These 3D Printers suited me though you may want different from is my suggestion.
Every part seen in above photo is 3D Printed STL is posted on this forum.
If you decide to purchase can be re-posted again.