Results 1 to 10 of 10
Threaded View
-
02-07-2021, 11:14 AM #5
- Join Date
- May 2020
- Posts
- 13
I don't think it burned out as it kept printing in the beginning and stopping after a few millimeters of print. and I took the stepper driver out of its socket when reattaching the heatsink as I needed to reapply heatsink adhesive.
is there a way to pull the firmware from the mainboard to put in a new one? I've reinstalled my windows since I made the changes and compiled the firmware, I can of course redo it all, but copying from this mainboard onto new one would save so much time.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion