Results 1 to 10 of 101
Thread: Network Printers
Threaded View
-
02-05-2021, 07:26 AM #25
You're really missing the point.
1) the robin has it's own propriatary 3.5 touch screen that connects with a ribbon cable. If you use this screen - great screen. Then the wifi module plugs into the board itself.
2) My module is connected and FULLY working - as is my 3.5 tft touchscreen.
3) when you connect to the router (which is what it basically is) this is the screen you get:
And that's ALL you get.
So what I need is a 'website' or 'webview' html to upload to the router to actually make it useful.
IT IS CONNECTED AND WORKING (lol)
I just have no idea how to do anything useful with it.
I just can't find any literature on what you have to do next.
I do know that with the mini delta (malyan setup) you could change the webview by uploading html and that would give you a better interface.
I don't want to have to go thorugh a raspberry pi.
There really should bhe a way to just upload a file to the sdcard via the network.
4) I do not need any other hardware, the screen is great thje wifi and networking are WORKING.
So if you could step away from the 'must upgrade' impulse and have a think about what you do when you get to the point where it actually works. That would be great :-)
This is the module I have:
As far as I can tell it's the latest version.
There are thousands of posts telling you how to connect the bloody thing. But absolutely nothing I can find that tells you what to do afterwards.
Oh yeah if i connect directly to the wifi network the module generates (use my phone) I get EXACTLY the same green screen.
Oh yeah - there is a phone app: mks cloud app.
You have to sideload it - BUT it is in CHINESE ONLY :-(
And i have to admit my written mandarin is a little sketchy.Last edited by curious aardvark; 02-05-2021 at 08:01 AM.
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion