Results 1 to 2 of 2
-
01-30-2021, 10:18 PM #1
- Join Date
- Jan 2021
- Posts
- 1
Prints on are not square on build plate side.
Hi I am trying to print https://www.thingiverse.com/thing:3174137 and when I try to put the pieces together they don't fit because my print is not square on the bottom. I never even noticed this all my other prints come out looking great. I leveled the bed and ran the level test print and looks like it's good. But when I print the calibration cube the bottom layer is a little rounded. Any ideas how I can fix this?
-
02-01-2021, 06:07 AM #2
- Join Date
- Aug 2020
- Location
- United Kingdom
- Posts
- 249
That sounds like the print warping of the build plate a little. You don't say what material you are using some warp much more than others. PLA is usually good ABS is often awful And some others well !!!!!!!!!!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion