Results 1 to 3 of 3
Threaded View
-
01-20-2021, 06:52 AM #2
your best bet is probably abs and use acetone smoothing.
polymaker also make a pla type filament that can be smoothd. But it's a more expensive solvent.
If the 3d45 isn't fully enclosed - it would be pretty simple to make it so and that's best for abs..
I know it's a replicator clone - just can't remember if it's fully enclosed and can't be bothered to go look :-)
Have a look at abs-x as well. Like abs but easier to print with and apparently no warping, so you don't have to design with shrinkage calculated.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help