Results 1 to 8 of 8
Thread: ‘Hover’ printing failure
Threaded View
-
01-08-2021, 05:37 PM #5
- Join Date
- Jan 2021
- Posts
- 3
I'm using Cura.
I've just now tried a new print with supports activated, placements set for everywhere and support overhang angle at 47 degrees.
I also raised the bed temp to 60, and selected brim at build plate adhesion type.
Now there is a new issue, and it seems that the print isnt handling the tit knit criss cross patterns, because its just messing it up and not connecting/binding photos are attached. If you have an idea on this I'd be grateful for your help. thumbnail_image0.jpgthumbnail_image2.jpg
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help