Results 1 to 8 of 8
Thread: ‘Hover’ printing failure
Threaded View
-
01-08-2021, 04:41 PM #2
- Join Date
- Jun 2014
- Posts
- 886
You'll want to locate the setting in your slicer for supports. Turn on supports and the slicer will create a print file that builds a series of walls or towers that sit where the droopies happen. After the print is complete, snap/cut/break them off and perform a bit of clean up.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help