Results 1 to 8 of 8
Thread: ‘Hover’ printing failure
Threaded View
-
01-08-2021, 04:41 PM #2
- Join Date
- Jun 2014
- Posts
- 885
You'll want to locate the setting in your slicer for supports. Turn on supports and the slicer will create a print file that builds a series of walls or towers that sit where the droopies happen. After the print is complete, snap/cut/break them off and perform a bit of clean up.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help