Results 1 to 10 of 16
Thread: ABS Warping
Threaded View
-
12-31-2020, 02:24 AM #14
- Join Date
- Feb 2016
- Posts
- 68
I have tried quite a few different bed surfaces. At the moment I have glass on the bed and use diluted with water PVA glue and that really makes prints stick.
If it is a stiff print and bigger than 1.5 inches it is very difficult to get off the glass. So bigger prints I just clean the glass.
If prints are difficult to get off I put water around the edges and after about 20 minutes they come off.
So looks like I stay with a glass bed surface unless something better comes along.
So no raft needed when using a glass surface.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion