Results 1 to 4 of 4
-
12-30-2020, 08:01 AM #1
- Join Date
- Dec 2020
- Posts
- 2
Flashforge Finder-Beginner Help Needed
Good Morning,
We are new to 3D printing, and just got a Flashforge Finder printer. Setup went well, and our test print of their cube was successful. Our next two prints (each of the same object) went bad at about 70% and then 75%. Seems like maybe the model is shifting on the bed? Can someone help us diagnose our problem?
-
12-30-2020, 09:02 AM #2
The model is releasing from the bed so you need to lower the nozzle
Depending on your firmware this can be done using the LCD an changing the Z-Offset value, or M851
-
01-01-2021, 04:37 PM #3
- Join Date
- Dec 2020
- Posts
- 2
-
01-01-2021, 05:55 PM #4
Here is a better explanation than I can give you.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion