Results 1 to 9 of 9
Threaded View
-
12-17-2020, 09:00 AM #8
- Join Date
- Dec 2020
- Posts
- 3
another nomination for the Sapphire Pro
I second the nomination for the Two Trees Sapphire Pro. Here is what I did to modify it to get some really nice ABS printswith all of these additions I'm about $ 450.00 in.Changed out the hot end to a E3D V6 all metal changed out the firmware to MarlinAdded BL Touch sensorAdded glass plate to compensated for the concave aluminum plateAdded corrugated plastic sheeting to all sidesI drilled a hole in the top left hand corner to route the cables through.this helps to get a good seal on the back coverWhat needs to be done but there is no hurrychange out the noisy power supply fan
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion