Results 1 to 10 of 23
Thread: Real World 3D Printer Comparison
Threaded View
-
11-30-2020, 07:07 AM #17
Weeellll, I did print a lattice cube - got it to just under 2 hours.
But the bloody thing is still stuck to the printbed and I didn't get out there over the weekend.
I usually use my print release hammer and a sharp tap releases most things - but with a large base and spindly lattice - that does not work ! Plus I'd forgotten to adjust my z-axis offset after simplify3d threw a wobbly last week.
So yeah, lol
I did it with three perimeters and 0% infill.
I'm interested to have a go on the delta with the 0.5mm nozzle and 2 perimeters.
The ends of the first lot of rods/angledbits/sides - whatever the hell you call them. were curling and catching - so when I left it it was making horrible noises and I was quite surprised to see it actually finished, was expecting a plate of spaghtti :-)Last edited by curious aardvark; 11-30-2020 at 07:14 AM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion