Results 4,101 to 4,110 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
Threaded View
-
11-14-2020, 10:21 PM #27
- Join Date
- Aug 2014
- Posts
- 627
I haven't used mine in years and years and honestly I no longer 3d print as it left a very sour taste in my mouth so I finally left it. If I need to one off something I will but mine came with the 8mm then they made the upgrade shortly after. To be honest it would be far cheaper, and faster, to purchase some rods and the bearings but the issue will come in with the plate as the holes for the bearings are not large enough so you will have to ream them out then that leads to the three mounting holes that then need to be drilled out. Qidi-tech, the last time I looked, had replacement parts on eBay though the last time I looked was in 2019. I don't think the price for that plate is expensive and I would suggest buying it from them then get the bearings and rods from a different source. I would contact them on eBay about the part.
Good luck.
P.S. Where they get expensive is in the consumables like the nozzle and the heated PCB.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery