Results 1 to 10 of 13
Threaded View
-
11-12-2020, 08:28 AM #9
- Join Date
- Jun 2014
- Posts
- 885
oh shucks, that's not what I expected. I had some other bearings left over from a project and replaced the entire rod/shaft with a new one. The roller spins so freely that a full spool unrolls and tangles, so I had to switch back to the original. I would not expect that is a critical factor, but if it improves TPU printing, I have it in reserve. I thought it was a reference to the pinch wheel on the extruder.
I think it's back to the gap between the feed mechanism and even more likely the too-high speed for such soft material.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)