Results 1 to 10 of 10
Threaded View
-
11-06-2020, 01:22 PM #8
I do this a lot - it's all about the perimeters. Slicers apply perimeters to the shell of a model but also put them round any holes/voids in the model.
so with three perimetyers on a 0.4mm nozzle - you will automatically get 1.2 mm of solid plastic on the outside of any screw holes.
Absolutely no need to use a lot of infill.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion