Results 1 to 10 of 12
Thread: 3D Printing of Small Bracket
Threaded View
-
11-04-2020, 10:07 AM #2
well apart from needing a few supports in the corners - it's a pretty simple print.
personally I would not get it in abs.
what's it for ?
ie what sort of weight will it support ?
I'll happily print you one for £25 :-)
PET would be my favourite, better than abs in all strength and heat aspects and a little more rigid as well as much better layer bonding - which seeing as those uprights are all vertical - is pretty important. .
Hell if it's not going to get hot - pla would probably be as good. But PET would most likely be the best.
where's the middle quote from ? ie: what material is it ? MF does not ring any bells.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help