Results 21 to 30 of 36
Thread: i need help badly
-
11-02-2020, 06:55 PM #21
- Join Date
- Aug 2020
- Posts
- 29
i am printing with pla 1.75 filament and i dont know how to do a temp tower
-
11-02-2020, 07:07 PM #22
That is a fairly high temperature for Printing PLA filament.
-
11-02-2020, 07:35 PM #23
- Join Date
- Aug 2020
- Posts
- 29
I am using 1.75mm pla and i dont know how to do a temp tower
-
11-02-2020, 07:36 PM #24
- Join Date
- Aug 2020
- Posts
- 29
sry for posting twice
what temp should i print at
-
11-02-2020, 07:37 PM #25
- Join Date
- Aug 2020
- Posts
- 29
and how would i do a temp tower
-
11-03-2020, 06:02 AM #26
Using Cura load a temp tower like this one on thingiverse
https://www.thingiverse.com/thing:2493504
Then Using tweak At Z-3.0.1 with Cura I find where the layer temp increase and using that layer enter in tweak At Z-3.0.1.
This means that I will be using 8 tweak At Z-3.0.1 for the 8 temperature changes.
The temperature is usually printed on the roll of filament.
On My machine I print PLA between 196- 206
Though printing a temp tower will show you the best filament temperature.Last edited by Roberts_Clif; 11-03-2020 at 06:07 AM.
-
11-03-2020, 07:28 AM #27
- Join Date
- Aug 2020
- Posts
- 29
can you find me a video
-
11-03-2020, 08:21 AM #28
-
11-03-2020, 06:34 PM #29
- Join Date
- Aug 2020
- Posts
- 29
The nozzle looked like it was not dispensing fast enough
-
11-04-2020, 06:19 AM #30
Nozzles have to be replaced once in a while they are in the list of consumables, though you may need increase the hot-end temperature for your filament.
Do you hear clicking, this could be a sign of the filament slipping causing under extrusion.
Printing time- Is this right?
09-13-2024, 07:51 AM in General 3D Printing Discussion