Results 1 to 10 of 36
Thread: i need help badly
Threaded View
-
11-01-2020, 04:14 PM #16
Thermister is shorted with a reading 310 °C or higher.
I would suspect that the Thermister is shorted unplug and measure the resistance of the thermister at room temperature Post resistance.
With Hot-end Thermister unplugged from controller board again turn on 3D Printer and post reading.Last edited by Roberts_Clif; 11-01-2020 at 04:35 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help