Results 1 to 10 of 17
Thread: printer died
Threaded View
-
10-31-2020, 09:17 AM #15
- Join Date
- Jun 2020
- Location
- South Carolina
- Posts
- 55
So I finally got my new power supply. It was easy enough to hook up - just moved wires straight from the old one to the same spot on the new. It turned on and everything seemed fine. But when I try to heat the bed or the nozzle it freezes with a "powering down" message. I can turn it off and back on. I can use the controls to move the nozzle around for a few seconds, then it will do it again.
So frustrating - I haven't been able to print since mid September.
Anybody know what could be causing this? I'm ready to just get a new printer. Problem is, the best deal for the money I can afford seems to be Tronxy and I'll have the same problem getting replacement parts.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help