Results 1 to 10 of 10
Threaded View
-
10-15-2020, 06:34 AM #6
I made them from transparent pla with 1mm thick walls. You can see the insects walking around inside them:
It's an example of how you can make fairly complex shapes without supports.
The beauty of 3d printing is that you can think of a thing that nobody else in the world has ever though of and inside a couple of hours actually hold it in your hand :-)
I'm currently printing a tool to smooth down masking tape.
Got a bunch of window frames to mask off - and something better than my gloved finger (they are outside) to get a really good flat application of tape was needed.
I've actually made three all slightly different in design to see which is best :-)
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion