Results 1 to 6 of 6
Threaded View
-
10-07-2020, 07:19 PM #2
- Join Date
- Jun 2014
- Posts
- 885
I've run into problems with my ABS prints on glass on a different printer. As the job cools, the print pulls pieces of glass out of the bed. I was astonished to see this. The solution I used, which fails occasionally, is to apply glue stick to the bed. I've noted that the X-max bed sticker also suggests using glue if something won't stick during a print, but the glue layer also makes things separate easier. When I've printed PETG on a Genuine Prusa, I also applied glue stick, as I learned that PETG will tear up the PEI layer on the Prusa.
Purple Elmer's Glue Stick™
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help