Results 1 to 4 of 4
-
09-30-2020, 10:56 AM #1
- Join Date
- Sep 2020
- Posts
- 2
Ender 5 Pro alarm going off failed to home please reset error
I put together a Ender 5 Pro printer. Immediately after building, the alarm went off after installation of newest firmware. The printer will power up, load a program, heat up and then, nothing. Printer Halted, Failed to home, Please reset!! ERROR!!, Please HELP!!
-
10-03-2020, 11:39 AM #2
- Join Date
- Aug 2020
- Location
- United Kingdom
- Posts
- 249
Have you tried reverting to "as delivered" software!
-
10-04-2020, 09:07 AM #3
- Join Date
- Sep 2020
- Posts
- 2
I’ve tried everything. I found a bin on creality’s website but it makes the extruder motor run backwards. The filament moves away from extruder head!!
-
10-04-2020, 09:58 AM #4
- Join Date
- Sep 2020
- Posts
- 4
Your printer cannot finish homing procedure.
This procedure require correct orientation of stepper motors and endstop logic.
Stepper motor direction per axis you can check from LCD.
If the stepper (/s) direction is reversed you need to either recompile Marlin firmware with changes or simply change motor cable pins order in the connector ( 1-2-3-4 -> 4-3-2-1 ).
If the endstop logic is wrong easiest way is to connect printer to a computer and access terminal (from software such as pronterface or Cura's monitor).
Then write into terminal command "M119" and it will show their current status:
- if not engaged endstop status should be "OPEN",
- when engaged status should be "TRIGGERED".
If you encounter problems with endstops check any faulty wires to be sure.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help