Results 1 to 5 of 5
Threaded View
-
09-28-2020, 03:51 PM #4
The Stratasys Uprint SE is an excellent printer. The build volume is a bit small by today's standards, but print quality is superb. I believe that it can only print ABS. The Stratasys support material works better than any other I've tried, but needs a weak solution of sodium hydroxide (lye) to dissolve it. I don't know if it's possible to reprogram the EEPROM. You might be able to wind another company's 1.75mm ABS on a Stratasys spool. Other companies sell Stratsys compatible filament in a variety of colors at a lower cost than Stratasys, but it's still not cheap. Here's one that sells colored ABS that they say works in both the SE and the SE Plus:
https://argylematerials.com/abs-p430...dditional-info
I just noticed this FAQ that shows how to wind new filament onto a Stratasys spool:
https://argylematerials.com/support/Last edited by jamcultur; 09-28-2020 at 04:04 PM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)