New 3d Printer Guy! Ender5 can't load filament! Sadfase!

[AutoWiz]

Hey buddy. What you need to fix this problem so it will never be a problem again is just get this: https://www.bondtech.se/en/product/bmg-extruder/ . It should be a direct bolt on fit. Allowing you to use the motor you already have. Then for the inlet you will get one of these to install on the bottom of the extruder: https://www.bondtech.se/en/product/f...ment-size=1-75 . Get the name brand stuff install it in the place of your extruder. Use the same motor. And make loading filament into your machine enjoyable. Using a printer shouldn't be a struggle. And with a bowden setup you would benefit from the dual drive anyways. But it's gotta be BondTech.