Well mission creep has officially set in. The Mosquito hotend comes with a 50watt heater cartridge and the wires that come with it are thicker than what is inside the drag chains. And I really want to add an external MOSFET for the extruder. Also The bondtech bmg-m mounts the nozzle a little further outboard from where the titan was. So I need to move the towers back a few mm on the Y so that the nozzle can reach all 400mm of the bed. And I need to swap the SKR 1.4 turbo for the SKR Pro I have. Sounds like the next rework but it shouldn't be that bad. I only have to design a new mainboard tray and extruder mount. I did try to download and print out various mounts just didn't find anything I liked. So it's time to rip this machine back down again. Electrical needs to come out so this can go in..