Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 18

Threaded View

  1. 09-23-2020, 05:52 PM #16
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Quote Originally Posted by pound View Post
    I found the M851 command to show my settings in the terminal at -12.80 instead of -2.80.
    Thanks for nothing friends!
    Not sure why but a few of those who request Help with A 3D printer, Then they give us as little information as possible to help us troubleshoot with.
    Then when they figure is out they blame us for not helping, an that they had to fix it themselves...

    You are defiantly wrong we were here from the start helping you fix your 3D Printer giving you information, this information helped you fix your 3D Printer.
    Plus we are only as good as the individual feeding us the information we request...

    So You are welcome Friend!!!!!

    Come AGAIN SOON.....
    Last edited by Roberts_Clif; 09-23-2020 at 06:03 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules