Results 1 to 4 of 4
Thread: Joining filament together
Threaded View
-
05-02-2014, 03:27 PM #3
Hey,
I've seen some info about this a while ago when i was searching for a solution aswell,
Searched it again and found some solutions.
http://forums.reprap.org/read.php?1,205562
http://www.thingiverse.com/thing:9850
Well for the last one you would need a drill , aluminium, saw and a resistor, But i would say that would probably be the best solution.
Also your Gcode wont be perfect anymore when you've done this, as your filament will easily be 0.05mm diffrent, wich is quiet a bit when your print tolerance is 0.1.Last edited by DrLuigi; 05-02-2014 at 03:29 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion