Pls help, Problems with Ender 3

[Roberts_Clif]

Thank you all for the help and sorry if it was a very amateur mistake I'm still learning the basics

We must all be amateur then, this mistake is made all the time an even by our so called professional 3D Printer operators.
As we get into a hurry and make a simple mistake when rebuilding or re-calibrating our bed leveling or nozzle height.

Even after calibrating for what should be the perfect height I still at time need to use baby steps when starting the 1st layer of a new model.
And over a few prints contentiously making small adjustments until it again is perfect, this is until calibration is knocked out again then it starts all over again.

My bed surface is glued to the heated bed though I quite often use a transfer Paper Tape on the aluminum bed surface of my older 3D Printer.
This transfer paper tape I use for a surface sometimes needs to be taped on the edges to keep it down.
I note this as see your surface is getting in the way of your nozzle and printing the 1st surface at the correct height...