Results 1 to 10 of 10
Threaded View
-
09-09-2020, 06:59 AM #2
sounds like your motherboard is playing silly buggers.
My first action would be to reset the firmware back to factory settings - usually there is a reset option somewhere in the printer control panel.
Failing that, a new board sounds like a good idea.
It seems to have reversed movement, and lost thermal control.
The obvious candidate would be the board. It might have overheated on that long print.
But definitely a soft reset would be the first thing I'd try.
And good to see you around the forum again :-)
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion